h0mel1fe. I have a Punto MK2b on a 2004, 1.2 8v. I have noticed that the radiator fan does not kick in when at operating temperature. I have replaced the Thermostat and the Coolant temp sensor, I have also replaced the female connectors on the temp sensor. I have bled the coolant and all seams to be well but the fan still does not kick in. Unfortunately I never managed to get to the bottom of this problem, the DRL's were working correctly, so just learned to live with yellow warning triangle. I changed the bulbs like for like with the ones that had blown, it may be worth making sure the exact same wattage and type from the owners manual. Here are a few approaches that can help resolve this issue. 1. Apply Lubricant: One of the most common causes of a stuck door is rust or debris accumulation on the door latches, hinges, or locking mechanisms. Applying an appropriate lubricant, such as WD-40, can help loosen the rust and free up the door. FIAT PUNTO GRANDE PUNTO Fuse I have a 2010 fiat punto. The remote key would not open or close doors or boot so I thought I had a problem with key. But then I realised that the electric mirrors and windows wont work on any door. The boot switch on dash wont open boot either so now im thinking a fuse. So i'd expect other dashboard related issues. LIke no fuel guage, no temperature guage, no little clock at bottom etc etc. 2 fuses tho are used to power it. F8 and F24, both 10amps. Id suspect a Communication problem or faulty dash. if no crank sensor wasn't working i;d say that was cause of dash - but engine runs yes? Apr 5, 2010. #2. Pop the rear washer out, remove hose and make sure its not the jet blocked. Operating the switch should produce water. If not, trace the pipework from the container/pump assy, and find the non return valve (wee plastic thing with arrow on it) If its blocked/failed, replace. Cheers. Re: Fiat Linea & Punto DIY: Speedometer Cluster LCD Repair. *Remove the glove box lid. *Remove the lower panel in the front central tunnel (only the left side one). *You will be able to locate the blower motor assembly behind the glove box compartment. * There will be two pairs of wires going into the resistor pack at the base of the blower assy. Jan 13, 2008. #1. I need to remove my Mk1 Fiat Punto Dashboard, Im doing some wiring work and changinge dash looms and i need ot get the dash off, ive undone lots of bolts, 3 from the top of the dash, a 14mm bolt from behind a panel in the glove box, 4 AK bolts from the bottom of the dash, a bolt holding the dash to the fusebox and all the fan I have disconnected the batery for a couple of hours and that seemed to work for a copuple of days but then has started to do it again. Its quite a new battery too so i dont think its that. Any ideas shane wbqm9h.

fiat punto dashboard not working